Tracing spindles FN6-1.1-B

The tracing spindles series FN6 have a shank receptacle and are used for drilling in a constant distance to the traced surface of the workpiece. So you get on uneven surfaces a constant distance relative to the surface with a tolerance of ± 0.05 mm. The tracing spindle must be provided with a tracing piece.

The material of the tracing piece should be chosen depending of the surface constitution. Available is a piece of steel or polyamid.

The tracing spindle FN6-1.1-B is always supplied together with a drive adapter according to your indications. It is necessary to indicate - in case of an order - the information regarding the drive adapter in question in addition to the article-number. Usually it is a machine specific adapter that is built corresponding to your machine. Corresponding to your order you will receive within our order confirmation a final Item Id. that was extended by the information referring to the adapter you ordered. This article-number. then applies for this specific configuration and can be used for all further orders without any additional information.

Variants on demand!