Vertical hollow mortiser DN-VCM

The vertical chisel mortiser DN-VCM can be used to make square holes. They have a tool spindle with a rotating tool holder and a fixed Inclusion Ø6x60 ø27x37 for square tools. The spindle direction is equal to the drive turning direction. The drive speed is transferred in a ratio of1:1 to the tool receptacle. The maximum spindle speed is 5,000 1/min in permanent operation.

The Direct receptacle is always supplied with a drive spindle according to your indications. It is necessary to indicate - in case of order - the information regarding the drive spindle in question in addition to the article-number. Usually it is a spindle according to the DIN / ISO regulations. Corresponding to your order you will receive within our order confirmation a final article-number that was extended by the information referring to the direct receptacle built for you. This article-number then applies for this specific configuration and can be used for all further orders without any additional information.

Variants on demand!